Minka Group F514-BN - Manual (Page 20)

10
INSTALLING THE GLASS SHADE & LIGHT BULBS
SWITCH CAP
LIGHT KIT
GLASS SHADE
BULBS
MATEL CAP
FINIAL
Fig .19
WARNING:Shut of the power supply before removing or replacing lamp. If you accidentally
come into contact,wipe thoroughly with a clean,lint-free,cotton cloth. Use light bulb in accordance
with the fan’s specification.TO REDUCE THE RISK OF FIRE DO NOT EXCEED MAXIMUM WATTAGE
RATING.
The color correlated Temperature (CCT) for replacing the enclosed lamp is (2700K).
The ballast in each of these models can be replaced by a qualified electrician without cutting of
wires and without damage to the housing, trim, decorative elements or carpentry to which the
fixture is attached. See installation steps for more detail.
ATTENTION:The Energy Policy Act of 2005 requires this fan to be equipped with a 190 watt
limiting device.If lamping execeeds 190 watts,the ceiling fan’s light kit will shut off automatically.
Step1. Install 2*13 GU24 CFL bulbs (included) into socket.(Fig.19)
Step2. Remove the rubber washer, metal washer, metal nut, switch cup and finial from the light kit
assembly. Place glass shade over the light kit stem, secure with the rubber washer, metal washer,
metal nut, matel cap and finial. Do not over tighten.(Fig.19)