Minka Group F522-ORB - Manual (Page 17)

9 INSTALLING THE GLASS SHADE & LIGHT BULB
WARNING:Shut of the power supply before removing or replacing lamp. If you accidentally come
into contact,wipe thoroughly with a clean,lint-free,cotton cloth. Use light bulb in accordance with
the fan’s specification.TO REDUCE THE RISK OF FIRE DO NOT EXCEED MAXIMUM WATTAGE
RATING.
ATTENTION:The Energy Policy Act of 2005 requires this fan to be equipped with a 190 watt
limiting device.If lamping execeeds 190 watts,the ceiling fan’s light kit will shut off automatically.
Step1. Install 3*60W E12 bulbs (included) into socket.(Fig.18)
Step2. Remove the rubber washer,metal nut, metal cup and finial from the light kit assembly. Place
glass shade over the light kit stem, secure with the rubber washer, metal nut, metal cap and finial.
Do not over tighten.(Fig.18)
Step3. Attach the pull chain fob to the chain on the light kit assembly.
Fig . 18
Bulb
Rubber washer
Metal nut
Metal cap
Finial
Glass shade