Minka Group F620-DBB - Manual (Page 19)

10
ATTENTION: The Energy Policy Act of 2005 requires this fan to be equipped with a 190 watt
limiting device. If lamping exceeds 190 watts, the ceiling fan's light kit will shut off
automatically.
1. Install 3 x 60W (Max.) candelabra base bulbs (included). (Fig. 19)
2. Remove the nut, metal washers, rubber washers and decorative nut from the light kit. Place
the rubber washer. glass shade, rubber washer and metal washers over the light kit stem.
Place the nut over the stem and turn it clockwise until it locks up against the glass shade.
Do not overtighten. (Fig. 19)
3. Raise the glass shade to the light kit and secure tightly with the glass cap and decorative
nut. DO NOT OVERTIGHTEN. (Fig. 19)
INSTALLING THE GLASS SHADE & LIGHT BULBS
Fig. 19
60W BULBS
GLASS SHADE
LIGHT KIT
GLASS CAP
DECORATIVE NUT
NUT
RUBBER WASHER
METAL WASHER
RUBBER WASHER