Minka Group F539-BN - Manual (Page 21)

SYMPTOM
Fan Wobble
SOLUTION
1.NOTE: All blade sets are grouped by
weight. Because wood and plastic
blades vary in density, the fan may
wobble even though blades are matched.
2Make sure outlet box is secured to
building structure, if necessary use
the wood screws provided to further
secure outlet box to joist.
3Make sure hanger bracket is secure to
the outlet box, screws are tight.
4 Use the balancing kit provided if the
wobble is excessive (follow instructions
included with balancing kit)
SYMPTOM
Fan will not start
SOLUTION
SYMPTOM
Fan will not start
SOLUTION
1. Allow a 24-hour "break in"
period.
Most noises associated
with a new fan will go
away during this time.
2 Make sure all blade
attachment screws are tight.
3Make sure outlet box is
secured to building structure, if
necessary use the wood
screws provided to further
secure outlet box to joist.
4Make sure hanger bracket
is secure to the outlet box,
screws are tight.
TROUBLESHOOTING
12
1.Check to make sure the wall switch is turned on.
2.Check circuit fuses or breakers.
3.Cantion! Make sure the power is turned
off before performing the following steps.
4.Remove canopy and check wire connections.
5.Check wall control transmitter connections
(if applicable).
6.Note: Fan must be installed from a maximum
distance of 40 feet from the transmitting unit
for proper signal transmission between the
transmitting unit and the fan's receiving unit.
SYMPTOM
Lights shut off and will not
come back on.
SYMPTOM
Fan/Light turn on and off
unexpectedly
1.This unit is equipped with a wattage
limiting device Lamping in excess of
190 watts will disable your ceiling
fans light kit. To reset your light kit
you must turn the power off and re-
lamp Keeping the wattage under 190
watts. Restore power to your ceiling
fan and continue normal operation.
2.This is caused by interference. Please
see “Frequency interference” for steps
to change the frequency.
SOLUTION
SOLUTION