Magikitch'n MKE Electric Griddle - Manual (Page 8)

Installation
MKE Series Electric Griddle
L20-369 REV. 2 (05/12) 8
1.2. VENTILATION AND FIRE SAFETY SYSTEMS
Your new appliance must have proper ventilation to function safely and properly. It is very important to install
a fire safety system. Your ventilation system should be designed to allow for easy cleaning. Frequent cleaning
and proper maintenance of the ventilation system and the appliance will reduce the chances of fire. Ventilation
and fire safety systems must comply to local and national codes. In North America, NFDA96 will provide
guidance on ventilation and fire safety systems.
2. Operation Section
Ensure that a proper installation has been performed on the appliance and that all warnings, cautions, and
notices contained in this manual have been read, understood and adhered to before proceeding.
2.1. Operation
2.1.1. Solid State And Electric Thermostat Appliances
1. Turn
the "I/O" switch to the “ I ” (ON) position for all desired thermostats to be operated.
2. Operate thermostats by turning knobs to the desired temperature. The "I/O" switch will illuminate when
the thermostat calls for heat.
Figure 8
2.2. Initial
Startup
NOTICE
New griddles should be carefully tempered and cared for in order to avoid possible damage. To break
in a new griddle, do the following:
WARNING
This equipment must be installed so that the plug is accessible unless other means for
disconnection from the power supply (e.g. a circuit breaker) is provided.
WARNING
If this appliance is permanently connected to fixed wiring, it must be connected by means
of copper wires having a temperature rating of not less then 167°F (75°C).
WARNING
All copper wiring for this appliance must be made in accordance with the wiring diagram(s)
located on the appliance.