MEGUIAR'S M135 - Manual (Page 4)

M135, Synthetic Spray Detailer (20-163B): M13501, M13516
__________________________________________________________________________________________
Page: 4 of 10
mg/m³: milligrams per cubic metre
CEIL: Ceiling
8.2. Exposure controls
8.2.1. Engineering controls
Use general dilution ventilation and/or local exhaust ventilation to control airborne exposures to below relevant Exposure
Limits and/or control dust/fume/gas/mist/vapours/spray. If ventilation is not adequate, use respiratory protection equipment.
8.2.2. Personal protective equipment (PPE)
Eye/face protection
The following eye protection(s) are recommended: Safety glasses with side shields.
Skin/hand protection
Gloves made from the following material(s) are recommended: Neoprene.
Natural rubber.
Respiratory protection
Select one of the following approved respirators based on airborne concentration of contaminants and in accordance with
regulations:
Half facepiece or full facepiece air-purifying respirator suitable for organic vapours and particulates
SECTION 9: Physical and chemical properties
9.1. Information on basic physical and chemical properties
Physical state Liquid.
Appearance/Odour Sweet, pleasant odour; Slightly milky, water-like liquid
pH 4 - 5
Boiling point/boiling range 100 ºC
Melting point Not applicable.
Flammability (solid, gas) Not classified
Explosive properties Not classified
Oxidising properties Not classified
Flash point Not applicable.
Autoignition temperature Not applicable.
Flammable Limits(LEL) Not applicable.
Flammable Limits(UEL) Not applicable.
Vapour pressure No data available.
Relative density 1.00 [Ref Std:WATER=1]
Water solubility Complete
Partition coefficient: n-octanol/water No data available.
Evaporation rate No data available.
Vapour density No data available.
Viscosity No data available.
Density 1 g/cm3
9.2. Other information
Volatile organic compounds (VOC) 1.71 % weight
VOC less H2O & exempt solvents 942.46 g/l