MEGUIAR'S MV85 - Manual (Page 4)

MV85, Low-Emission Mold Seal & Release (XP4-53A): MV8501, MV8505
__________________________________________________________________________________________
Page: 4 of 16
Contain spill. Collect as much of the spilled material as possible using non-sparking tools. Working from around the edges
of the spill inward, cover with bentonite, vermiculite, or commercially available inorganic absorbent material. Mix in
sufficient absorbent until it appears dry. Remember, adding an absorbent material does not remove a toxic, corrosivity or
flammability hazard. Clean up residue with an appropriate solvent selected by a qualified and authorised person. Ventilate
the area with fresh air. Read and follow safety precautions on the solvent label and Safety Data Sheet. Place in a metal
container approved for transportation by appropriate authorities. Seal the container. Dispose of collected material as soon as
possible.
6.4. Reference to other sections
Refer to Section 8 and Section 13 for more information
SECTION 7: Handling and storage
7.1. Precautions for safe handling
Do not handle until all safety precautions have been read and understood. Keep away from heat/sparks/open flames/hot
surfaces. - No smoking. Ground/bond container and receiving equipment. Use only non-sparking tools. Take precautionary
measures against static discharge. Use explosion-proof electrical/ventilating/lighting/equipment. Avoid breathing
dust/fume/gas/mist/vapours/spray. Do not get in eyes, on skin, or on clothing. Do not eat, drink or smoke when using this
product. Wash thoroughly after handling. Wear low static or properly grounded shoes. Use personal protective equipment
(eg. gloves, respirators…) as required. Avoid contact with oxidising agents (eg. chlorine, chromic acid etc.) Vapours may
travel long distances along the ground or floor to an ignition source and flash back.
7.2. Conditions for safe storage including any incompatibilities
Store away from acids. Store away from oxidising agents. Keep container tightly closed. Store in a well-ventilated place.
Keep cool. Store away from strong bases.
7.3. Specific end use(s)
See information in Section 7.1 and 7.2 for handling and storage recommendations. See Section 8 for exposure controls and
personal protection recommendations.
SECTION 8: Exposure controls/personal protection
8.1 Control parameters
Occupational exposure limits
Ingredient CAS Nbr Agency Limit type Additional comments
Ethylbenzene 100-41-4 Health and
Safety Comm.
(UK) TWA:441 mg/m3(100
ppm);STEL:552 mg/m3(125
ppm) Skin Notation
Toluene 108-88-3 Health and
Safety Comm.
(UK) TWA: 191 mg/m³ (50 ppm);
STEL: 384 mg/m³ (100 ppm) Skin Notation
Naphtha (petroleum),
hydrotreated heavy 64742-48-9 Manufacturer
determined
TWA:100 ppm
Health and Safety Comm. (UK) : UK Health and Safety Commission
TWA: Time-Weighted-Average
STEL: Short Term Exposure Limit
ppm: parts per million
mg/m³: milligrams per cubic metre
CEIL: Ceiling
8.2. Exposure controls
8.2.1. Engineering controls
Use general dilution ventilation and/or local exhaust ventilation to control airborne exposures to below relevant Exposure