Asus L1N64-SLI WS - Manual (Page 51)

ASUS L1N64-SLI WS 2-2
• For a fully configured system, we recommend that you use a power supply
unit (PSU) that complies with ATX 12 V Specification 2.0 (or later version)
and provides a minimum power of 600 W.
• Do not forget to connect the 4-pin/8-pin ATX +12 V power plug; otherwise,
the system will not boot up.
• Make sure to connect the EZ Plug™ when using two PCI Express graphics
card and a 20-pin ATX power supply unit; otherwise, the system will be
unstable.
• Use of a PSU with a higher power output is recommended when
configuring a system with more power-consuming devices. The system
may become unstable or may not boot up if the power is inadequate.
9. Front panel audio connector (10-1 pin AAFP)
This connector is for a chassis-mounted front panel audio I/O module that
supports either HD Audio or legacy AC`97 audio standard. Connect one end
of the front panel audio I/O module cable to this connector.
• We recommend that you connect a high-definition front panel audio
module to this connector to avail of the motherboard’s high-definition audio
capability.
• By default, this connector is set to [AC97]. If you want to connect a high-
definition front panel audio module to this connector, set the Front Panel
Type item in the BIOS to [HD Audio]. See page 4-23 for details.
L1N64-SLI
WS
L1N64-SLI WS Analog front panel connector
AAFP
Legacy AC ‘97 audio
pin definition
SENSE2_RETUR
POR
T1 L POR
T2 R POR
T2 L
SENSE1_RETUR
SENSE_SEND POR
T1 R
PRESENCE#
GND
NC
MIC2 Line out_R Line out_L
NC
NC MICPWR
NC
AGND
HD Audio-compliant
pin definition