KEMP Hyper-V 2012 - Manual (Page 14)

Copyright © 2002 - 2014 KEMP Technologies, Inc. All Rights Reserved. Page 14 / 20
Virtual LoadMaster for Microsoft Hyper-V
Installation Guide
Figure 2-9: Appliance Vitals
15. Click the System Configuration menu option.
16. Click the eth0 menu option within the Interfaces section.
17. In the Network Interface 0 screen, enter the IP address of the eth0 interface, the
network facing interface of the LoadMaster, in the Interface Address input field.
18. Click on the Set Address button
19. Click on the eth1 menu option within the Interfaces section
20. In the Network Interface 1 screen, enter the IP address of the eth1 interface, the farm-
side interface of the LoadMaster, in the Interface Address input field.
21. Click on the Set Address button
This interface is optional, depending on the network configuration.
22. Click on the Local DNS Configuration > Hostname Configuration menu option.
23. In the Hostname configuration screen, enter the hostname into the Current Hostname
input field.
24. Click on the Set Hostname button.
25. Click on the Local DNS Configuration > DNS Configuration menu option.