Rhin-O-Tuff OD4012 User Manual
Page 14
12
u
OD4000 Manual Reverse
Locate the silver plug
on the rear of the left side panel of the
machine. Remove the silver plug by prying it
out gently with a small flat tool. Insert the end of a large flat blade
screwdriver into the open hole and engage with the end of the motor
shaft. Rotate the screwdriver counterclockwise 5-10 revolutions, until
the punch pins have been retracted back to the starting position.
Remove most or all of the material from the punch. Remove the
screwdriver from the punch and replace the small silver plug. Plug
the power cord back into the wall outlet and turn the power switch on.
Test cycle the machine by punching with no material in the punch, the
machine will reset itself back to its home position. Reduce the
amount of material being punched and continue working.
Turn the machine
power switch off and unplug the power
cord from the wall.
!
WARNING
Crush hazard.
Keep hands away
from moving parts.
Lockout and disconnect
power before servicing.
It is easier to remove one or two sheets at a time from the
backside of the material in the punch.