NaceCare Solutions TP400F - Manual (Page 3)

3
Construction of the machine
The TP400F is constructed with the following parts:
• Solution and recovery tanks
• Air compressor box
• Foam brush applicator and solution hose
• Vacuum hand tool and vacuum hose
The machine is comprised of:
• The air compressor and the compressed air tank, located in the air compressor box
• The solution tank, containing the water and chemical solution used to clean
• The recovery tank, used to recover the dirt sucked with the vacuum motor,
• The solution pump and the vacuum motor, situated inside the solution tank,
• The control panel for the pump and for the motor,
• The control panel for the compressor and air pressure regulator.
Preparation for use
To prepare the machine for use:
1. Insert the male quick disconnect fitting (located at the end of the solution hose coming
out from the foam regulation panel) into the female quick disconnect fitting (located at the
pump outlet). This way you allow the water from the pump to enter the panel where the
foam is created.