NaceCare Solutions TP18SXHP - Manual (Page 6)

6
In most cases, If the carpet being cleaned is in good condition and regularly maintained this
step may be skipped.
STEP C – RINSING WITH CLEAN WATER ONLY
 Close the chemical input valve on the lower control panel.
 Turn the pump on
 Turn the vacuum motor on
 Proceed with extraction cleaning, using the carpet wand and spraying clean water only.
NOTE: After switching the pump OFF, you must discharge the built up pressure in the line.
Simply pull the trigger on the accessory to discharge the pressure. If this is not done, the
pump may have trouble starting the next time the switch is turned on.
NOTE: Once the solution tank becomes empty, you must empty the recovery tank before re-
filling the solution tank. Failure to do so can possibly cause damage to the vacuum motor.
Maintenance
1. After every use, before storing the machine, remove all the water from the solution and the
recovery tank. Also make sure to rinse out the recovery tank before storing.
2. After every use, store the machine in a cool and dry place with the dome cover open. Water that
is left in the recovery tank with the dome lid left on will evaporate through the vacuum motor and
will cause premature damage to it. This type of failure is not covered under warranty.
3. Periodically clean the water filter, removing it from the machine and rinsing it under warm water.
4. Periodically check and clean the filter of the vacuum motor, which is located under the dome lid
of the upper tank.
5. After 500 working hours, the machine should be checked by a local service agency. Parts that
require inspection and replacement at this time are: Carbon brushes, pump seals and filters.
6. Worn carbon brushes may result in damage to the vacuum motor. This type of failure is not
covered under warranty.