NaceCare Solutions RM1800H - Manual (Page 7)

STEP C – HIGH PRESSURE RINSING
In order to high pressure rinse, the nozzle must be changed from the low pressure chemical
application setting. Moving the spray nozzle towards the trigger easily does this. You can
vary the spray from pinpoint to a fan pattern.
1. Verify that the pump switch is on and work in a circular motion once again.
2. Spray clean the floor brush and set it aside
3. Pressure wash the fixtures from the top to the bottom.
4. For sinks pinpoint spray the faucets and fan spray the rest to rinse, this should take 7
to 10 seconds each.
5. For urinals pinpoint spray the manual flusher then fan spray the rest to rinse, this
should take 15 to 18 seconds.
6. For toilets pinpoint clean the manual flusher, lift the seat clean hinges and seat
bottom. While still on pinpoint place the nozzle under the rim and rotate, then spray
into the bowl and around the bottom and base. Finish with a fan rinse of the fixture;
this should take 30 to 40 seconds.
7. When you are finished with the pressure hose, loop and dry the hose and hang it on
the machine.
8. Bring the floor brush out of the room and hang it on its holder on the machine
STEP D – SQUEEGEE MIRRORS AND FLAT SUFACES
If you decided to spray the mirrors at this time you can now squeegee the water off of the
mirrors and hard surfaces including counter tops and partitions.
STEP E – VACUUMING THE FLOOR
After completing the above procedures you can vacuum the solution from the floor.
To vacuum the liquid, proceed as follows:
1. Connect the vacuum hose to the vacuum port at the rear of the machine
2. Connect the hose to the wand
3. Switch the vacuum motor on.
4. Vacuum floor from the front or door to the rear, this will keep the hose clean and dry.
5. Vacuum grouted tile on a 45-degree angle for better pick up.
6. Return the hose to the machine and loop it back on its holders