NaceCare Solutions RM1800H - Manual (Page 5)

Preparation for work
To prepare the machine and the area to be cleaned follow these steps:
1. Fill the fresh water solution tank, use the fill hose supplied or a clean bucket
2. Select the dilution tip then verify that the chemical line is well connected, also check the
chemical concentrate level
3. On the high pressure hose Insert the male quick disconnect coupling (located at the end
of the high pressure hose) into the female quick disconnect coupling (located on the
control panel).
4. Connect the spray/rinse gun to the high pressure hose
5. Connect the plug of the machine to a grounded electrical socket. If the electrical socket
does not have a built in GFI (Ground Fault Interrupter) please use the GFI provided.
Carefully read the instructions in the safety instructions paragraph.
6. Prepare the area to be cleaned by picking up the large debris and flushing any toilet or
urinal that requires it
7. Remember to wear gloves, goggles, and any other necessary safety equipment required
by law in your area.