NaceCare Solutions NR1520 - Manual (Page 11)

11
TROUBLE SHOOTING GUIDE
THE MACHINE DOES NOT CLEAN EFFICIENTLY
(IT FLUTTERS OR SWINGS)
If the machine has been stored in the upright position
with the pad on it, the pad may have been deformed by
the weight of the machine. Replace the pad/brush to
correct this problem.
THE MACHINE STOPS WHILE WORKING
Check that the circuit breaker on the rear of the handle
has not tripped.
If the circuit breaker trips repeatedly, contact you nearest
NaceCare Solutions service centre.
CARBON BRUSH WEAR INDICATOR
The machine is equipped with a sensor for the Carbon-
brushes. When the red light is illuminated (see “drawing”)
the carbon brushes need to be replaced. ONLY
AUTHORIZED NaceCare Solutions SERVICE CENTRES MAY
PERFORM SERVICE ON THESE MACHINES.