NaceCare Solutions TP8X - Manual (Page 2)

2
Safety instructions (read carefully)
Every electrical device must be used only for the function it is intended for, respecting the manufacturer’s
instructions. Failure to follow the instructions could result in serious bodily injury to the operator (electric
shock, electrocution, etc.). Irresponsible use may put people in serious danger. Carefully read the following
points and be sure to understand everything before using the machine.
Before connecting the plug to the electrical outlet, check that the voltage available at the socket is the same
indicated on the label of the machine.
• Be sure that the electrical system is well grounded.
• Verify that the plug is the same configuration as the wall outlet.
• Do not use adapters or multiple sockets.
• This heater is not recommended for use with extension cords. If an extension cord must be used,
ensure that the extension cord has the correct gauge of wire.
• If the cable becomes damaged (tears, exposed wires), it must be replaced with a new one.
• Do not pull the machine by the cable. Also, do not pull the plug out of the wall by the cable
• Do not handle the plug with wet hands.
• Do not spray water near the outlets. Do not use the machine to spray or to suck corrosive liquids
(acids or bases), explosive or inflammable liquids (gasoline, kerosene, solvents, etc.) or dust.
• Do not use the device in an explosive atmosphere.
• Do not let the device to be used by children and persons unable to understand the danger connected
with the use of electrical power.
• If the machine does not function correctly, switch off the machine and pull out the plug.
• After using, store the machine, well cleaned, in a dry and enclosed place.
• Only qualified personnel may perform service to this machine.
IMPORTANT NOTE: This heater must be used on a different power supply to the carpet
extractor. Using the same power supply will cause the circuit breaker to trip if used on the
same power supply (For 15A and 20A services). If 2 outlets are not available, follow the
steps indicated below.
1. See page 7 for instructions on pre-heating the water. Pre-heat the water in the solution
tank to the desired temperature
2. Unplug the heater and use the hot water in the solution tank for Carpet extraction.
3. Refill the solution tank and follow steps 1 and 2 as necessary.
This way you will still be able to heat the water without having 2 separate electrical services.