Monster Power Reference PowerCenter HTS 3600 - Manual (Page 26)

18
NUMBERS REFER TO DRAWINGS ON PAGE 16
10. Voltage/Amperage Toggle: Allows you to view either the Input Voltage or System Current Draw LED Readout.
11. Dimmer Button: Adjusts the meter illumination or the amount of light to the Digital LED Readout.
12. ON Switch: Once the PowerCenter is plugged into a properly grounded 120V outlet, pressing this button
will provide AC power to the components plugged into the PowerCenter’s Switched and Switched (Timed) outlets.
13. OFF Switch: Press this button to shut down Switched and Switched (Timed) components.
14. Ground Screw: This screw provides a ground reference point, for any ungrounded components,
15. Digital Isolation Filter (Unswitched Outlets): These outlets have a special filter circuit that is designed
to reduce interference to your digital components. Make sure to match the appropriate Identification Sticker
to each component’s power cord.
IMPORTANT NOTE It does not harm video components or audio components to be connected
to the digital filter section. However, for the best possible performance, we recommend plugging
in only digital components here.
16. Video Interference Reduction Filter (Unswitched Outlets): These outlets have a special filter circuit
that is designed to reduce interference to your video components. Match the appropriate Identification Sticker
to each component’s power cord.
IMPORTANT NOTE It does not harm audio components or digital components to be connected
to the video filter section. However, for the best possible performance, we recommend plugging
in only video components here.