Fagor GRP-8 - Manual (Page 10)

9
EN
the contacts.
• ALWAYS CONNECT THE GRILL TO A
PLUG WITH AN APPROPRIATE EARTH
CONNECTION: DO NOT USE TYPE “T”.
• WARNING: During installation: Do
not place on any surfaces or near any
walls, partitions, kitchen cabinets or
similar unless they are made of non-
flammable material or have a suitable
non-flammable heat insulating coating,
and always observe fire prevention
regulations.
When using electrical appliances, always
respect the basic safety guidelines in
order to reduce the risk of fires, electric
shocks and/or injury. These guidelines
include the following measures:
• Before using the appliance for the first
time, read these instructions carefully
and keep them for future consultation.
• Before using for the first time, check
that the main voltage coincides with
that indicated on the appliance’s
characteristics plate.
• The electrical safety of the appliance is
guaranteed only when connected to an
efficient earth installation, as stipulated
in current electrical safety regulations.
The manufacturer accepts no
responsibility for damage derived from
a failure to connect the appliance to an
earth installation. If in doubt, contact a
qualified professional.
• To protect against electric shocks, do
not submerge the appliance, the cable
or the plug in water or any other liquid.
• The user should never try to replace
the cable. If the cable were to become
damaged or need replacing, this should
be carried out only by a Technical
Assistance Service authorised by the
manufacturer, since the task requires
special tools.
• Never use any electrical appliance if
the cable or plug are damaged or if the
appliance does not work properly or
has been damaged in any way. Take
the appliance to an authorised technical
service for examination, repair or
adjustment.
• Do not let the cable hang over the
edge of the table or worktop, or come
• ATTENTION: Before using the unit for
the first time, remove stainless steel
plastics protection and clean using
no abrasive detergent. The set should
not be put in places near to fuels or
susceptible of deformation by heat. In
case this is not possible, one should
coat the place with a good thermical
insulating and not combustible material.
• The grill should not be installed close
to inflammable or heat deformation
products. If this is not possible, the grill
working-place has to be isolated with a
good thermic non-inflammable material.
• Before connecting the grill to the power
supply, check if the circuit specifications
are correctly adjusted to the grill power.
The electric board (power mains) should
have a 30mA protection and a circuit
breaker with a 3mm separation between
3. SAFETY WARNINGS
1. PRODUCT DESCRIPTION
2. TECHNICAL CHARACTERISTICS
a. Heater plaques
b. Appliance ON pilot light
c. Temperature selector
d. Covers
e. Grill plate handle
f. Grill plate turning knob
g. Drip tray
h. Handle
i. Allen key
Electromagnetic Compatibility: The
interference of this appliance has
been suppressed in accordance with
Electromagnetic Compatibility Directives.
This appliance complies with the EEC
directives relating to food contact materials.
Voltage - Frequency: 230V~50Hz.
GR 4L GR 6L GR 8L
Volume (L) 4.1 6.1 8
Power (W) 1800 3000 2100