Fagor REIN-652I - Manual (Page 26)

26
2.2.2 Display backlight time adjustment
The duration of the display backlight when a button is pressed can be adjusted. To
adjust it, hold down the
-
and buttons for 5 seconds, and then press the
-
and
buttons again. You can use the
+
/
-
buttons to adjust the time, increasing it 15
seconds at a time from 0-90 seconds. If you adjust it to 0 there will no backlight. The
default confi guration is 30 seconds.
To return to the initial screen press the
-
and buttons again, although if no buttons
are pressed it will automatically exit this mode after 120 seconds.
PROGRAMMING (MODEL IP ONLY)
3
The IP Eco-Heater offers the possibility of Individual Programming:
24 hours a day, seven days a week. The advantages of programming the appliance are:
• It can be programmed to suit your needs.
• An optimum temperature is maintained in each room of the house.
• Power optimisation and savings.
The Programming is done according to the Date and Time and the different operating modes:
Day Mode, Night Mode and Anti-Frost Mode (
, ,
).
On programming an Eco-Heater you should take into account the room conditions and the opera-
ting mode (
, , ) you wish to set for the seven days of the week.
Press the button until the programming indicator (time scale) appears
on the display. The Eco-heater is now in Programming mode.
The Eco-Heater comes with its own programming set by default. To
change this programming, follow the instructions given below. Firstly, after
it has been switched off, the date and time will need to be set on the
appliance’s internal clock.
Hold down the button for 5
seconds. The time on the internal
clock will appear on the display.
The days of the week (represented by
numbers from 1 to 7) appear on the
middle of the display.
Press the
+
and
-
buttons to move
forwards or backwards until the
clock shows the correct time. If you
hold the button down it will scan
through the times faster. When the
24-hour cycle is complete it will then
run through the days of the week:
2 (Tuesday) will appear, and so on
until it reaches 7 (Sunday).
a
a
b
c
Setting the Date and Time
a
a c b
5
SEG.
If the button is not pressed for 120 seconds, the
appliance will automatically exit Programming mode.
IMPORTANT