Fagor REIN-652I - Manual (Page 21)

21
English
Install feet on underside of
radiator, push them in fully.
The legs may be screwed in place.
Before inserting the screws, align
each leg with the vertical lines on
the eco-heater, so that the holes
in the leg (where the screws are
to be inserted) coincide with the
holes in the eco-heater. Tighten
the screws until the legs are fi rmly
fi xed to the appliance.
NOTE: On 650W eco-heaters,
only one leg may be screwed in to
the central part of the eco-heater.
It is therefore recommended to fi t
the legs in place without screwing
them in.
Position the radiator on the fl oor
where appropriate, respecting
minimum distances indicated in
Figure 1.
a
b
c
One Ø 4.8 x 16 screw
for each leg
potential ledge
Figure 1
250 mm minimum (side of controls) 100 mm minimum
150 mm
minimum
25 mm
minimum
PROFILE
wall or
nearest
object
wall or nearest
object on the
right wall or
nearest object
on the left