Agri-Fab PRO 125 User Manual

Page 5

FIGURE 6

FLOW CONTROL

LINK

VINYL GRIP

FLOW

CONTROL

ARM

1/4" x 5/8"
HEX BOLT

SMALL HOLE

1/4" HEX
LOCK NUT

14. Assemble the leg stand tube to the handle tube (long)

using two 1/4" x 1-1/2" hex bolts and two 1/4" hex lock
nuts. Tighten. See figure 5.

15. Place the vinyl cap on the leg stand tube. See figure 5.

16. Assemble the flow control link (the long end with the

small hole) to the flow control arm using one 1/4" x 5/8"
hex bolt and one 1/4" hex lock nut. Do not over tighten.
The flow control link must pivot freely. See figure 6.

17. Place the vinyl grip on the flow control arm. See figure

10. Assemble the (long) handle tube to the side of the

crossover tube opposite the shaft support plate, as
shown in figure 4. Fasten the handle tube to the middle
hole using the bolt, flat washer and hex lock nut which
you removed in step 9. Do not tighten yet.

IMPORTANT: DO NOT assemble the handle tube to the
side of the crossover tube where the shaft support plate is
located. When the spreader is placed in the upright position,
the handle tube must be on to the top side of the crossover
tube. Refer to figure 17 on page 9.

11. Assemble the end of a handle brace to the inside of each

leg of the hopper tube frame, using a 1/4" x 1-3/4" hex
bolt and 1/4" lock nut for each brace. See figure 4. Do
not tighten yet.

12. Assemble the other end of both handle braces to the

handle tube using a 1/4" x 1-3/4" hex bolt and 1/4" hex
lock nut. Do not tighten yet. See figure 4

13. Tighten in sequence the bolts and nuts that were

assembled in steps 10, 11 and 12.

FIGURE 5

HANDLE TUBE (LONG)

1/4" HEX
LOCK NUT

VINYL CAP

LEG
STAND
TUBE

1/4" x 1-1/2"
HEX BOLTS

HANDLE TUBE (LONG)

HEX BOLT
1/4" x 1-3/4"

HANDLE
BRACE

SHAFT
SUPPORT
PLATE

MIDDLE BOLT,
WASHER & NUT

1/4" HEX
LOCKNUT

CROSSOVER
TUBE

FIGURE 4