Fagor BC-500 - Manual (Page 9)

8
7. WARNING: DO NOT OVERLOAD
THE SCALES
If the load capacity is exceed, the scales
may be damaged and the following warning
will appear on the display:
1. Set the scales to zero as explained
above.
2. Position the measuring beaker then
press lightly and release. The
display will revert to zero in a few
seconds.
NB: The letter "T" will be displayed on
the left.
3. Now you can add the other items you
want to measure in the measuring
beaker. Repeat these two steps as often
as required. The net weight of the item is
shown on the display.
4. If you start removing the items from the
beaker, you will see a negative number (-)
which represents the weight of the item
you have removed.
If you wish, you can reset the scales to
zero by pressing
every time you
remove an item.
NB: When you switch on the scales for
the first time, if the display does not
read zero, you can also press the
button.
8. BATTERY LOW INDICATOR
When the battery needs replacing, the
following message will appear on the
display:
When this happens, follow the adjustment
instructions.
Remember that batteries are
not household waste. Spent
batteries must be disposed
of in the special containers
provided.
9. USING THE TARE BUTTON (3)
10. MAINTENANCE AND CLEANING
1. These scales are a precision
instrument. Make sure they receive no
knocks. Do not store the scales with a
weight on them for long periods.
2 Always press the buttons gently. Do not
beaker from the scales. If this is not
possible, hold the edge of the measuring
beaker with your finger to present the
measuring beaker from tipping over, as
shown in Fig.3
8. The scales will turn themselves off after
one minute if you do not weigh anything.
To turn the scales off manually, press
for 3 seconds.