Decolav 5230 - Manual (Page 5)

CAMERON MODULAR SERIES
Customer Service: 561-274-2110
www.decolav.com LET YOUR DREAMS COME ALIVE, YOUR PASSIONS
BECOME REALITY, BE THE ENVY OF YOUR NEIGHBORS ®
5
Customer Service: 561-274-2110
www.decolav.com LET YOUR DREAMS COME ALIVE, YOUR PASSIONS
BECOME REALITY, BE THE ENVY OF YOUR NEIGHBORS ®
INSTALLING A DRAWER CONSOLE AND THE SUPPORT LEG TO THE VANITY
Connecting
Bolt (4 Total)
There are 2 holes on each end panel of the vaity.
The holes are bored half way through the panel
from the factory. Customer will bore holes all
the way through. Bore all both hole through the
panel when hooking up the Drawer Console or
the Vanity Drawer.
T-Nut (4 Total)
o Unpack the Drawer Console, Vanity and Support Leg.
o Remove the door and drawers from the Drawer console and the Vanity. (This will make installation a lot
easier)
o Look inside the Vanity, you will see 2 holes near the top of the Vanity. These holes are bored halfway
through from the factory. On the side that you wish to hook the drawer console or the Vanity Drawer to,
bore the holes all the way through using a .394” (10 mm) drill bit.
o Lay Vanity and Drawer Console on the fl oor, back down.
o Slide the Drawer Console next to the Vanity lining up the holes at the top.
o Using the connecting bolts and T-nuts attach the drawer console to the Vanity. The connecting
T-nuts go on the Drawer console side and the Connecting Bolts go on the Vanity side. Tighten connecting
bolts and insert three small wood screws into the holes in the T-nut. This will lock the T-nut in place. Figure
C
o There will be 3 unused holes at the bottom of the Drawer console (below bottom panel). These holes are
for connecting screws. Install the 3 screws through the drawer console and into the vanity using a
cordless screwdriver. Figure D
o Place the support leg next to the drawer console. Line up the the preinstalled insert nut holes
with the holes in the end panel of the drawer console. Figure C
o Using the connecting bolts attach the support leg to the Drawer console. Only 2 connecting bolts will be
used. At the bottom of the drawer console there are 3 screw holes (below the bottom panel) Install screws
into the support leg using a cordless screwdriver. Figure D
Figure C
Flat Washer (4 Total)
Small Wood Screw
(12 total)
Factory
Installed
insert nut
(2 total)