Decolav 5264 - Manual

Customer Service: 561-274-2110
www.decolav.com LET YOUR DREAMS COME ALIVE, YOUR PASSIONS
BECOME REALITY, BE THE ENVY OF YOUR NEIGHBORS ®
1
•160211•
VANITY INSTALLATION INSTRUCTIONS
• DO NOT OVERTIGHTEN DRAIN. Overtightening of the drain can damage your DECOLAV
®
product.
• DO NOT clean the product with Detergents, Acid, Abrasives, Harsh Cleaners or a cloth with a coarse surface (S.O.S.
®
Pads, Scotch Brite
®
Pads). This is good advice for any plumbing fi xture regardless of material.
• DO NOT leave any cleaning agents other than water on your DECOLAV
®
product.
• DO NOT allow your DECOLAV
®
product to unnecessarily encounter other solid objects.
• DO clean your DECOLAV
®
product. Wipe with a damp cloth and dry with a soft cloth. If necessary, a general mild soap and water solution
can be used. Use a mild furniture polish to clean wood frame.
CARE AND CLEANING
RECOMMENDED TOOLS
Tape Measure Scroll Saw Drill Pencil Level
STEP #1
o Carefully remove vanity from carton and place safely aside.
o Turn off water supply to faucet.
o Remove existing vanity.
o Determine the location on the wall where the vanity will be installed.
o Measure the vanity width and height and mark outline on wall.
o Locate and mark wall studs. .
STEP #2
o Measure and mark the location of plumbing pipes and
lines.
o Make cutout in back using a circular or saber saw
allowing enough room for plumbing lines or pipes.
(See Figure 1).
o Carefully position the vanity in desired location.
o Level the vanity side-to-side and front-to-back using
a carpenter’s level and ajust leg levelers. (Leg levelers
are located on the bottom of each leg.
o Drill 3/16" (0.48 cm) diameter holes in vanity back
where screws will be positioned and centered on wall
stud. (See Figure 2). Drill through the top back rail and
back panel, DO NOT drill through back panel alone.
Figure B
Figure A
Customer to mark and
make cutout
Notes:
o Pictured vanity may be diff erent that actual vanity. This document is for instructional purposes only
o We recommend two people to install this vanity
Top Back Rail