Track rack – American Bicycle Security Company Track Rack User Manual
Page 6
American Bicycle Security Company
P.O. Box 7359
Ventura, CA 93006
Ph: (800) 245-3723 or (805) 933-3688
Fax: (805) 933-1865
Track Rack
*Tools Needed for Installation
9/16” Wrench/Socket
¾” Wrench/Socket
¼” Drill Bit or 3/8” Masonry Drill Bit (depending on
anchor type)
Tape Measure
Drill (Hammer Drill Recommended)
Hammer
Level
Saw for cutting rack
Installation Instructions – Wall Mount
Installation Steps
Before installing: Make sure the wall is strong enough to
accommodate the rack fully loaded with bikes. Compare
parts shipped with rack to parts list. Call ABSCo if any
parts are missing.
1. Mount 24” Slotted Tracks vertically to the wall
with the appropriate anchors. Use a level for
greatest accuracy. The bottom edge of the
Slotted Track should be approximately 72” off
the floor. The Slotted Tracks should be 4’ apart
from each other, and the end Slotted Tracks
should be 2’ from the eventual position of the
end of the Trolley track.
2. Mount the remaining 24” Slotted Tracks
horizontally and protruding from the wall so
that the slotted surface of the Slotted Track is
4.25” below the top edge of the vertical 24”
Slotted Track. Use the Knee Braces, Angle
Brackets, and the Spring-loaded Nuts and Hex
Head Cap Screws to secure the horizontal
Slotted Track in place.
3. Make sure the horizontal Slotted Track is level.
Adjust if necessary.
4. Attach the Track Rack to the Wall Mount
assemblies by securing the Channel Trolley
Supports to the horizontal 24” Slotted Track
with the remaining Spring-loaded Nut and Hex
Head Cap Screw. The edge of the Slotted Track
Mounting Bracket should be flush with the
edge of the 24” Slotted Track.
5. Follow the installation instructions for the basic
Track Rack unit to complete the assembly.
1.
2.
3.
4.