Track rack – American Bicycle Security Company Track Rack User Manual
Page 4
American Bicycle Security Company
P.O. Box 7359
Ventura, CA 93006
Ph: (800) 245-3723 or (805) 933-3688
Fax: (805) 933-1865
Track Rack
*Tools Needed for Installation
9/16” Wrench/Socket
¾” Wrench/Socket
¼” Drill Bit or 3/8” Masonry Drill Bit (depending on
anchor type)
Tape Measure
Drill (Hammer Drill Recommended)
Hammer
Level
Saw for cutting track
Installation Instructions – Ceiling Mount
1. Mount Channel Trolley Supports in ceiling
with appropriate anchors so that the
centers of the brackets are 2 feet from
each end of the 96” Slotted Track and 4
feet apart from each other.
2. Slide 96” Slotted Track through the
Channel Trolley Supports so that the
centers of the brackets are 2 feet from the
end of the Slotted Track.
3. Secure the Channel Trolley Supports onto
the 96” Slotted Track by tightening the Hex
Head Cap Screws and Flange Nuts through
the holes in the Channel Trolley Supports.
4. Hammer an End Cap into one end of the
96” Slotted Track.
5. Insert the Trolleys into the open end of the
96” Slotted Track.
6. Insert the hooks through the holes in the
tabs that are hanging down from the
Trolleys. Each hook length should be at
least 3” different than the neighboring
hook.
7. If no more Track Racks are going to be
spliced together, hammer in another End
Cap in the open end of the Slotted Track to
close it up.
8. If splicing an additional length of track,
slide the Splice Slotted Track over the last
6” of the 96” Slotted Track.
Recommended Base Install Material
Note: if installing a ceiling mounted Track Rack, continue
with the assembly by following the directions below. If
installing a wall mounted or floor mounted model,
assemble those units according to their instructions first.
Installation Steps
Before installing: Make sure the ceiling is strong enough to
accommodate the rack fully loaded with bikes. Compare
parts shipped with rack to the parts list on the previous
page. Contact ABSCo if any parts are missing. Make sure
the 96” Slotted Track will fit in your space. If necessary,
cut the Slotted Track to
the required length.
1.
2.
3.
4.
5.
6.
8.