Cycle stall basic – American Bicycle Security Company Cycle Stall Basic User Manual
Page 3
American Bicycle Security Company
P.O. Box 7359
Ventura, CA 93006
Ph: (800) 245-3723 or (805) 933-3688
Fax: (805) 933-1865
Cycle Stall Basic
*Tools Needed for Installation
9/16" socket set
(2) 4"x4"x28" (or larger) blocks
(4) bolts, nuts & washers for each rack.
If using tamper resistant nuts, install two
tamper-resistant & two standard nuts with
each rack.
Installation – Racks
Installation Steps:
Installation steps:
1. Lay out the two channel beams where the
rack will be placed. Place both beams on
top of the two blocks of wood so that the
open part of the channel faces the ground.
2. Place racks on beams so holes in rack
flanges line up with beam slots.
3. Put bolts through Hoop Rack flange holes &
beams so bolt head faces up. HAND tighten
the nuts using new flange nuts.
4. Once nuts are on, tip assembled rack over
& use a 9/16" socket to tighten nuts.
Before tightening nuts, make sure the
racks are straight on beams. If using
tamper resistant nuts, use access tool to
tighten nuts. Do not over tighten the
tamper resistant nuts. Tip rack upright.
Anchoring Rails:
To anchor the rails to concrete, place 3.75"
wedge anchor through holes in the rail into the
concrete. Secure with nut.
If anchoring to asphalt surface, use Titen
asphalt screws. Place screws through rail holes
and turn into the asphalt.
1.
2.
3.
4.