Bike file – American Bicycle Security Company Bike File Rack User Manual
Page 6
American Bicycle Security Company
P.O. Box 7359
Ventura, CA 93006
Ph: (800) 245-3723 or (805) 933-3688
Fax: (805) 933-1865
Bike File
*Tools Needed for Installation
9/16” Wrench/Socket
3/4” Wrench/Socket
1/4” Drill Bit or 3/8” Masonry Drill Bit (depending
on anchor type)
Tape Measure
Drill (Hammer Drill Recommended)
Hammer
Level
Saw for cutting rack
Wall Mount – Installation
Installation Steps:
Before installing, Make sure the wall is strong enough to accommodate
the rack fully loaded with bikes. Compare parts shipped with rack to
parts list. Call us if any parts are missing.
1. Mount 24” Slotted Tracks vertically to the wall with the
appropriate anchors. Use a level for greatest accuracy. The
bottom edge of the Slotted Track should be approximately
72” off the floor. The Slotted Tracks should be 4’ apart
from each other, and the end Slotted Tracks should be 2’
from the eventual position of the end of the Trolley track.
2. Mount the remaining 24” Slotted Tracks horizontally and
protruding from the wall so that the slotted surface of the
Slotted Track is 4.25” below the top edge of the vertical
24” Slotted Track. Use the Knee Braces, Angle Brackets,
and the Spring-loaded Nuts and Hex Head Cap Screws to
secure the horizontal Slotted Track in place.
3. Make sure the horizontal Slotted Track is level. Adjust if
necessary.
4. Attach the Bike File to the Wall Mount assemblies by
securing the Channel Trolley Supports to the horizontal
24” Slotted Track with the remaining Spring-loaded Nut
and Hex Head Cap Screw. The edge of the Slotted Track
Mounting Bracket should be flush with the edge of the 24”
Slotted Track.
5. Follow the installation instructions for the basic Bike File
unit to complete the assembly.
1.
2.
3.
4.