Removing the installed optical drive cable, Installing the replacement optical drive cable, Closing the server – Apple Optical Drive Cable User Manual
Page 4
Xserve Optical Drive Cable -
4
Removing the Installed Optical Drive Cable
1.
Disconnect the optical drive cable from the optical drive.
2.
Disconnect the cable from the drive interconnect board and remove the cable from the
server.
(Figure 3)
Figure 3
Installing the Replacement Optical Drive Cable
Connect the replacement optical drive cable to the drive interconnect board and the
optical drive.
Closing the Server
1.
Carefully slide the bottom housing back into the rack.
2.
Tighten the front thumbscrews to secure it.
Warning: Never turn on the server unless all of its internal and external parts
are in place and it is closed. Operating the server when it is open or missing
parts can damage it or cause injury.