Vaddio REVEAL - Manual (Page 12)

REVEAL IN-Wall Cameras
REVEAL IN-Wall Camera Manual Document Number 342-0059 Rev. A Page 12 of 28
The Quick-Connect Interfaces and Basic Configurations
• HD-18 Quick-Connect SR Interface (used with REVEAL Systems 999-6925-000, 999-6925-001, 999-6935-000 and
999-6935-001):
Connectors:
1) Power Input: 24 VDC, 2.0 Amp Power Connection, 5.5mm OD x 2.5mm ID, Positive Center.
2) EZCamera POWER & HD VIDEO: The Cat. 5e connection supplies 24 VDC power to the REVEAL and returns HSDS differential
video from the camera. Maximum distance on the CAT-5 cable is 100 feet (30.5 m)
3) HD VIDEO OUTPUT: DE-15F (15-pinHD) connector outputs the YPbPr analog component video from the REVEAL camera.
Note: The REVEAL also puts out SD video (480i/30fps & 576i/25fps) in YPbPr analog component format.
4) IR OUTPUT Ports: With the IR pass-thru function (IR OUT) turned on at the camera (see Camera Switch Settings section), it is
possible to send IR from third-party IR remote controls to third-party equipment, such as videoconferencing codecs. IR can be
output as either modulated (for IR Probe) or non-modulated (direct connection) signals for added flexibility in codec connection.
5) RS-232 Input & Output RJ-45 Jacks: The RS-232 INPUT RJ-45 accepts signals from controllers and the RS-232 OUTPUT is
connected to the camera, although this port can be bypassed when not using 3rd party IR remotes. When using the IR pass-thru
function, the IR signals are pulled from the REVEAL from the RS-232 Output Cat. 5e cable.
System Connectivity Example: Featuring the REVEAL Camera, HD-18 Quick-Connect SR Interface & Precision Camera Controller.
①
② ③
⑤
④
Vaddio ProductionVIEW Precision Camera
Controller
Rear Panel of the HD-18 Quick-Connect SR Interface (1/3 Rack Width Enclosure)
Two (2) - Cat. 5e Cables
Up to 100’ (30.48m) Power to Camera
HD Video from REVEAL
REVEAL IN-Wall
Camera System
RS-232
Resolution
Set at Camera
YPbPr
*Simulated Video Feed
RS-232
RS-232
HD Monitor*