General installation instructions – Vaddio Quick-Connect DVI-HDMI SR User Manual

Page 7

Quick-Connect DVI/HDMI - SR Interface

System Connectivity Example 2:

System connectivity of Vaddio HD-18 Cameras and Quick-Connect DVI/HDMI - SR

Interfaces Configured with Single Control Port Codec with Daisy Chain Control Emulation (DCCE).

General Installation Instructions:

Like all Vaddio Cat 5e cabling systems, the Quick-Connect DVI/HDMI - SR is easy to install and operate.
The HD-18 product was specifically designed with Cat 5 cable connectivity for Power, Video and
Control/IR signaling and only two Cat 5e cables are required from the Quick-Connect camera. Installation
is simplified in that no custom 8-Pin mini-din cables or expensive multi-core plenum cables are needed
and no power outlets are required near the camera bracket. All cabling is routed to the head-end using
Cat 5e cables.

Before Installing

• Locate the camera mounting position while paying close attention to camera viewing angles, lighting

conditions, possible line of site obstructions, and checking for in-wall obstructions where the camera
is to be mounted. Pick a mounting location to optimize the performance of the camera.

• Pre-wire cabling as required (see wiring diagram examples).

• The provided Thin Profile Wall Mount for the HD-18 can be mounted directly to a 2-gang wall box or

can be mounted to the drywall using the provided four (4) dry wall anchors.

Installation:
1) Use the accompanying HD-18 manual to set the switch settings for HD video out resolution, IR

frequency and output, baud rate, SD video format and shape, image orientation etc…

2) After determining the optimum location of the camera system, route the required 2 (two) Cat 5e

cables from the camera to the Quick-Connect interface located at the head-end.

Vaddio HD-18

HD Camera Systems

DVI to HDMI
Cable

Daisy Chain Link between
Quick-Connect Interfaces

DVI Cable

Computer
with DVI
Output

C60 Codec

Microphones

ETHERNET

DVI Cable

Single RS-232 Port Codec with
Daisy Chain Camera Control

Codec IR Remote:
Forwarded through
Main Camera for
Codec Control

RS-232

Two (2) - Cat 5e
Cables - up to
100’ (30.48m)

Power to Camera
HD Video from
Camera - Cat. 5

RS-232 & IR Return Cat 5e

Two (2) - Cat 5e
Cables - up to 100’
(30.48m)

RS-232 & IR Return Cat 5e

HD Video Monitors*

*Simulated Video Feeds

Monitor 1

Monitor 2

DVI-D

HDMI

Quick-Connect

DVI/HDMI SR

Interfaces