Power Soak 33529 Skewer Wash Owner's Manual - Manual (Page 23)

19
Wash Pump Will Not Operate
Owner/Manager Check List
Review the control panel lights and complete the following procedures.
If these steps do not allow the machine to start, contact the Power Soak
service department (800-444-9624) or an authorized service company.

No lights on the control panel:
o Power is turned off; check the main circuit breaker to see
that it is turned on.
o Power supply is defective; call a service company to
restore power to the machine.
o Water temperature is above 135°F.

Green light is flashing:
o Liquid level in the wash sink is below the top sensor; fill the
wash sink to the waterline.
o Liquid level sensor is dirty and does not detect the water
level; clean the liquid level sensors as described in the
“Preventive Maintenance” section of this manual. (The liquid
level sensors are the white plastic disc with a metal center
located on the side walls of the wash and sanitizer sinks.)
Service Company Check List
The Owner/Manager Check List (above) must be verified. If there are
no lights on the control panel, check the following:

Main power connection and wiring

Fuse inside the control enclosure

Bi-metallic disc switch for water temperature (switch must be
closed if water temperature is below 120°F)

Bi-metallic disc switch for motor temperature (switch must be
closed if motor temperature is below 150°F)
Check to see that the Liquid Level LEDs #3 and #4 are illuminated
when the wash tank is filled to the waterline. If either one or both of the
lights are not illuminated, see that all connections to and from the liquid
level sensors are secure and that there is no physical damage to the
wiring. In the event that damaged connectors and/or wiring are found,
contact Power Soak Systems, Inc. at 800-444-9624.
If the troubleshooting guidelines do not correct the problem, it will be
necessary to contact Power Soak Systems, Inc. at 800-444-9624.