Pitco Frialator 45C+ with Millivolt Gas Valve - Manual (Page 2)

L20-275 Rev. 1 9/13
TO THE PURCHASER, OWNER AND STORE MANAGER
Please review these warnings prior to posting them in a prominent location for reference.
TO THE PURCHASER
Post in a prominent location the instructions to be followed in the event that an
operator smells gas. Obtain this information from your local gas supplier.
FOR YOUR PROTECTION
DO NOT store or use gasoline or other flammable vapors and liquids in the
vicinity of this or any other appliance.
Do not spray aerosols in the vicinity of this appliance when it is in operation.
WARNING
Improper installation, operation, alteration, adjustments, service or
maintenance can cause property damage, injury or death. Read the installation,
operating and maintenance instructions thoroughly before installing, operation,
servicing this appliance.
WARNING
Installation, maintenance and repairs should be performed by a Pitco
Authorized Service and Parts (ASAP) company technician or other qualified
personnel. Installation, maintenance or repairs by an unauthorized and
unqualified personnel will void the warranty.
WARNING
Installation and all connections must be made according to local codes in
force. In the absence of local codes in North America, the installation must
conform with the National Fuel Gas Code, ANSI Z223.1/NFPA 54 or the
Natural Gas and Propane Installation Code CSA B149.1 as applicable. In
Australia, the appliance must installed in compliance with AS/NZS 5601.
WARNING
During the warranty period if a customer elects to use a non-original part or
modifies an original part purchased from Pitco and/or its Authorized Service
and Parts (ASAP) companies, this warranty will be void. In addition, Pitco and
its affiliates will not be liable for any claims, damages or expenses incurred by
the customer which arises directly or indirectly, in whole or in part, due to the
installation of any modified part and/or received from an unauthorized service
center.
WARNING
Adequate means must be provided to LIMIT the movement or this appliance
without depending on the gas or electrical cord connection. Single appliances
equipped with legs must be stabilized by installing anchor straps. All
appliances equipped with casters must be stabilized by installing restraining
chains.
WARNING
DO NOT alter or remove structural material on the appliance to accommodate
placement under a ventilation hood.
WARNING
If the appliance is equipped with a power cord and it is damaged, it must be
replaced by a Pitco Authorized Service and Parts (ASAP) company technician,
or a similarly qualified person in order to avoid a hazard.
WARNING
The power supply must be disconnected before servicing, maintaining or
cleaning this appliance.
WARNING
The appliance is NOT jet stream approved. DO NOT clean the appliance with a
water jet.
WARNING
DO NOT attempt to move this appliance or transfer hot liquids from one
container to another when the unit is at operating temperature or filled with hot
liquids. Serious personal injury could result if skin comes in contact with the
hot surfaces or liquids.
WARNING
DO NOT use an open flame to check for gas leaks!
WARNING
DO NOT sit or stand on this appliance. The appliance’s front panel, tank, splash
back, tank cover, work shelf, drain board is not a step. Serious injury could
result from slipping, falling or contact with hot liquids.
WARNING
NEVER use the appliance as a step for cleaning or accessing the ventilation
hood. Serious injury could result from slips, trips or from contacting hot
liquids.
WARNING
The oil/shortening level should NOT fall below the minimum indicated level line
at any time. The use of old shortening can be dangerous as it will have a
reduced flash point and be more prone to surge boiling.
WARNING
Completely shut the appliance down when shortening/oil is being drained from
the appliance. This will prevent the appliance from heating up during the
draining and filling process. Serious injury can occur.
WARNING
This appliance is intended for indoor use only.
WARNING
DO NOT operate appliance unless all panels and access covers are attached
correctly.
WARNING
It is recommended that this appliance be inspected by a qualified service
technician for proper performance and operation on a yearly basis.
WARNING
There is an open flame inside this appliance. The unit may get hot enough to
set nearby materials on fire. Keep the area around the appliance free from
combustibles.
WARNING
DO NOT supply the appliance with a gas that is not indicated on the data plate.
If you need to convert the appliance to another type of fuel, contact your dealer.
WARNING
If gas flow to appliance is interrupted, or pilots extinguish, wait 5 minutes
before attempting to relight the pilot to allow any residual gas in appliance to
dissipate.
WARNING
Ensure that the appliance can get enough air to keep the flame burning
correctly. If the flame is starved for air, it can give off a dangerous carbon
monoxide gas. Carbon monoxide is a clear odorless gas that can cause
suffocation.
WARNING
Never add oil to the appliance when it is at operating temperature. Splashing
hot oil can cause severe injuries.
WARNING
Never add water to hot oil. Violent boiling can occur causing severe injury.
WARNING
This appliance is intended for professional use only and should be operated by
fully trained and qualified personnel.
WARNING
To avoid splashing of hot liquid when installed, this fryer must be restrained
either by the manner of installation, or with adequate ties to prevent tipping.
WARNING
An appliance equipped with casters and a flexible gas line must be connected to
the gas supply with a quick disconnect device. In North America, gas appliances
equipped with casters must be installed with connectors that comply with the
Standard for Connectors for Movable Gas Appliances, ANSI Z21.69.CSA 6.16
Latest Edition. This connection should include a quick disconnect device that
complies with the Standard for Quick Disconnect Devices for Use With Gas Fuel
ANSI Z221.41.CSA 6.9 Latest Edition. In Australia, an appliance equipped with
casters and a flexible gas line must be connected to the gas supply with a quick
disconnect device that complies with AS 4627. The hose must comply with
AS/NZS 1869 and be class B or D and have a restraining cable. The restraining
cable must not exceed 80% of the length of the flexible gas line.