HOUNO Visual Cooking I B - Manual (Page 5)

B – ver. 1.3 – Sept. 2005
5
Entering and changing data in steps
By pressing STEP when PROGRAM is active, the step display is turned on and shows ”1”. The
data of the first step can now be entered.
To move on to the next step (1-3) and read and change settings, press STEP again.
Choose and change temperature, time, core temperature, exhaust and fan as in manual operation.
Stop between steps: To turn the alarm between steps on and off, press ALARM. If the control lamp
is on, the program ends with the current step and a beep is heard. The oven does not proceed to the
next step until the oven door is opened and closed or you press ALARM.
To store a change made in the step mode, press PRG for 2 seconds.
Leave STEP by choosing another program with the turn switch.
Delete current step by pressing STEP and ALARM simultaneously for 2 seconds.
When the program has started, you can still change time, temperature, core temperature and the
settings of fan and exhaust. These changes will then only be active in the current run. Note that the
display shows the total time remaining after start and that it will show the time remaining in the
current step when you press TIME.