Dynatek 2002-2005 Harley Davidson V-Rod Models - Manual (Page 3)

From the right side of the bike, unplug the
fuel injector connectors. Pull the harness
down so it is out of the way. Note that there is
a label on them for "FRONT" and "REAR"
cylinder.
Take the FIC harness, and feed it under the
throttle bodies, then through to the right side
of the bike. On the FIC harness, find the 2
connectors with the orange wire. Plug these
into the front injector harness, and then into
the front injector. The yellow wire with the
green stripe on the stock harness should
connect to the red wire on the FIC harness.
On the FIC harness, find the 2 connectors
with yellow wire. Connect these to the rear
injector harness, then to the rear injector.
Once all of the injector wires are connected,
gently pull the extra slack in the harness back
through the left side of the bike.The yellow
wire with the green stripe on the stock
harness should connect to the red wire on the
FIC harness.
STEP
4
STEP
6
STEP
5
STEP 4
STEP 6
STEP 5
Installation
Part# DFCH-5 3