Dynatek 2002-2005 Harley Davidson V-Rod Models - Manual (Page 2)

Tools required: 5mm Hex wrench, 10mm
socket, pliers
Lift the seat. Remove the airbox cover.
Unplug the sensor at the front of the airbox.
Undo the 8 clamps on the airbox, and remove
the lid. There are 3 clamps on each side, 1 at
the front and 1 at the rear. Remove the air
filter. Using the 5mm Hex wrench, remove the
3 bolts at the base of both of the air horns
inside the airbox.
Use the pliers to loosen the clamp on the
breather hose that goes from the airbox to
the rear cylinder head. Remove the breather
hose. Lift and remove the airbox.
Place FI Controller (FIC) on battery. Route
wiring harness down left side of bike. On the
FIC harness, locate the black wire with with
the ring terminal. This needs to be grounded
to the bolt that is on the front cylinder head.
Use a wire tie to secure the FIC harness to
the stock wiring harness.
STEP
1
STEP 3
STEP 2
Installation
Part# DFCH-5 2
STEP
3
STEP
2
STEP 1
Ground
Tie