Fig .g fig .h fig .i – Dynatek D2K14-1SE User Manual

Page 5

ID2K14-1SE

www.dynaonline.com

2010-2012 Hyundai Genesis 2.0T Coupe - 5

FIG

Locate and unplug the stock wiring harness from the vehicle’s

Manifold Absolute Pressure sensor (Fig. G).

The MAP sensor is located on top of the intake manifold on the

driver’s side of the engine.

Plug the 2000SE wiring harness in-line of the MAP sensor and the

stock wiring harness (Fig. H).

If you are also using the Dynojet CMD, make sure to connect the

2000SE in-between the MAP sensor and the CMD harness. This

would leave the CMD to be plugged in-between the 2000SE and the

stock wiring harness. Connecting in this order will ensure that the

2000SE will see actual MAP sensor voltage, and not the “clamped”

sensor voltage from the CMD.

Locate and unplug the stock wiring harness from the vehicle’s

Throttle Position Sensor.

The TPS is located on the throttle body at the driver’s side of the

engine compartment.

Unplug

ID2K14-1SE.01