Dynatek D2K14-1SE - Manual (Page 3)

ID2K14-1SE www.dynaonline.com 2010-2012 Hyundai Genesis 2.0T Coupe - 3
FIG
.A
FIG
.B
FIG
.C
Unplug
ID2K14-1SE.01
1 Open the hood.
2 Disconnect the negative terminal of the vehicle’s battery.
3 Use the supplied Velcro strips to secure the Dynatek 2000SE module
to the top of the fuse box (Fig. A).
Use the supplied alcohol swab to clean the surface of dirt, grease, or
oil, prior to attaching the Velcro. This will ensure secure adhesion.
4 Remove the plastic cover from the top of the engine (Fig. B).
5 Locate and unplug the stock connectors for the vehicle’s Crank
Position Sensor (Fig. C).
This pair of connectors is located at the rear of the engine towards
the driver’s side.