Alpine cda-9886 - Manual (Page 41)

39
-EN
01GB06CDA9886.fm
ALPINE CDA-9886 68-09359Z43-A (EN)
• Secure the ground lead of the unit to a clean metal spot using a
screw (* 3 ) already attached to the vehicle’s chassis.
USB memory Connection (sold separately)
Connect USB memory
Connect USB memory to USB cable.
Remove USB memory
Pull out USB memory squarely from the USB cable.
• When removing USB memory, pull it out straight.
• If sound is not output or USB memory is not recognized even when USB
memory is connected, remove USB memory once, then connect it again.
• Change to a source other than the USB memory mode, then remove
the USB memory. If the USB memory is removed in the USB memory
mode, data may be damaged.
• Route the USB cable away from another cables, etc.
Front Frame
Screws (M5 × 8)
(Included)
Mounting Bracket
Ground Lead
This unit
* 3
Cable (sold separately)
USB memory
(sold separately)
This unit
USB connector
This unit
USB connector
Cable (sold separately)
USB memory
(sold separately)
01GB00CDA9886.book Page 39 Friday, September 28, 2007 10:20 AM