Panasonic SC-PM200 - Manual (Page 4)

E
N
G
L
IS
H
ENGLISH
RQT9547
4
4
Preparing the remote control
R6/LR6, AA
(not included)
Use alkaline or manganese battery.
Install the battery so that the poles (+ and –) align with
those in the remote control.
Point the remote control at the remote control sensor
(Z 5), away from obstacles, at a maximum range of 7 m
directly in front of the main unit.
CAUTION!
• Do not break open or short-circuit the battery.
• Do not charge the alkaline or manganese battery.
• Do not use the battery if the cover has peeled off.
• Do not heat or expose to flame.
• Do not leave the battery(ies) in an automobile exposed
to direct sunlight for a long period of time with doors and
windows closed.
• Mishandling of battery can cause electrolyte leakage,
which can cause a fire.
• Remove the battery if you do not use the remote control
for a long period of time. Keep in a cool, dark area.
CAUTION!
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type
recommended by the manufacturer. Dispose of used
batteries according to the manufacturer’s instructions.
Placement of speakers
The right and left speakers are the same.
You cannot remove the net of the speakers.
Use only the supplied speakers.
The combination of the main unit and speakers give the
best sound.
You can cause damage to the system and decrease the
sound quality if you use other speakers.
Note:
• Keep your speakers more than 10 mm from the main unit
for ventilation.
• Put the speakers on a flat safe surface.
• These speakers do not have magnetic shielding. Do
not put them near TVs, PCs or other equipment easily
influenced by magnetism.
• When you play at high levels for a long period, it can
cause damage to the system and decrease the life of
the system.
• Decrease the volume in these conditions to prevent
damage:
– When you play distorted sound.
– When you adjust the sound quality.
CAUTION!
• Use the speakers only with the recommended
system. If not, you can cause damage to the
amplifier and speakers and can cause a fire.
Consult an approved service personnel if damage
occurs or if there is a sudden apparent change in
performance.
• Do the procedures included in these instructions
when you attach the speakers.
Making the connections
Conserving power
The system consumes approximately 0.2 W when it is in
standby mode. Disconnect the power supply if you do not
use the system.
Some settings will be lost after you disconnect the system.
You have to set them again.
2 3
B
4
(6 :) (6 :)
A
A
1
B
To household
mains socket
Red
Black
Click!
1 Connect the speakers.
Be careful not to cross
(short-circuit) or reverse the
polarity of the speaker wires
as doing so may damage the
speakers.
2 Connect the FM indoor antenna.
Place the antenna where reception is best.
3 Connect the AM loop antenna.
4 Connect the AC mains lead.
Use the included AC mains lead with this system only.
Do not use an AC mains lead from other equipment.
PM200_EP_1gb.indd 4 PM200_EP_1gb.indd 4 5/9/2011 5:15:44 PM 5/9/2011 5:15:44 PM