Antunes, AJ VCT-1000 - Manual (Page 16)

VERTICAL CONTACT TOASTER
16 P/N 1010807 Rev. E 06/06
TROUBLESHOOTING (continued)
Problem Possible Cause Corrective Action
Product is overly-toast-
ed or Platen heat is too
high or drop time is too
slow.
Temperature set too high. Set temperature control to a lower setting.
Bun Thickness Compression
Knobs set improperly.
Measure bun thickness and set Bun Thickness
Compression Knobs correctly (Figure 7).
Buns sticking on Release Sheet. Clean or replace Release Sheet according to the pro-
cedure in the Maintenance section of this manual.
Conveyor Cover Assembly not
installed properly.
Re-install Conveyor Cover Assembly.
Loose sprocket setscrews. Check drive chain for kinks, broken or bent links,
or other damage. Check motor sprocket and drive
sprockets; tighten setscrew on flat of shaft if required.
Check for damaged/worn sprocket and replace as
required.
Conveyor Belt Chain too loose. Adjust Conveyor Belt Chain length as described in the
Maintenance section of this manual.
Spring Tensioner Assembly or
Roller Tensioner is damaged or
missing.
Replace Spring Tensioner Assembly or Roller
Tensioner if damaged or missing.
Product is under toast-
ed or Platen heat is too
low or drop time is too
fast.
Bun Thickness Compression
Knobs set improperly.
Measure bun thickness and set Bun Thickness
Compression Knobs correctly.
Wiring problem. Contact your maintenance person or Authorized
Service Agency for service.
Inoperable Thermostat.
Conveyor Drive Motor inoper-
able or incorrect conveyor motor
installed in toaster.
Product is getting
stuck or Conveyor Belt
Chains stop when prod-
uct is toasting.
Bun Thickness Compression
Knobs Set improperly.
Measure bun thickness and set Bun Thickness
Compression Knobs correctly.
Release Sheet not cleaned
properly or is missing.
Clean or replace Release Sheet as described in the
Maintenance section of this manual..
Conveyor Drive motor inopera-
tive or incorrect conveyor motor
installed in toaster.
Contact your maintenance person or Authorized
Service Agency for service.
Conveyor Drive Chain loose,
worn, or broken. Loose motor
drive sprocket.
Check drive chain for kinks, broken or bent links,
or other damage. Check motor sprocket and drive
sprockets, tighten setscrew on flat of shaft if required.
Check for damaged/worn sprockets and replace as
required.
Conveyor Belt Chain too loose. Adjust Conveyor Belt Chain length as described in the
Maintenance section of this manual.
Spring Tensioner Assembly or
Roller Tensioner is damaged or
missing.
Replace Spring Tensioner Assembly or Roller
Tensioner if damaged or missing.