Configuring nat, Enabling nat, Setting ring tones – AltiGen comm IP 710 User Manual
Page 32

24
IP 710 Manual
—INIT NETWORK
—LOADING FW...
—LOADING NOW.
—Boot Done
—INITIALIZING
10. You may verify the new version of firmware: Press the Menu button,
scroll to SYSTEM and press Enter, scroll to Version Info and
press Enter.
Configuring NAT
Note:
This section is only for an IP 710 phone that is using an H.323
version of AltiGen phone firmware.
NAT (Network Address Translation) is the translation of an IP address
used within one network to a different IP address known within another
network. One network is designated as the inside network, the other is the
outside. The IP 710 can be enabled to support H.323 behind NAT. The IP
710 will be able to work behind a regular NAT router without any special
implementation for H.323.
Note:
If more than one IP 710 phone sits behind NAT, a VPN tunnel is
required to connect between the NAT router and the corporate
router.
Enabling NAT
By default, NAT is not enabled. If you connect the IP 710 behind a NAT
router, you must enable NAT.
To enable NAT,
1. Press the Menu button.
2. Use the
button to scroll to NETWORK, then press the Enter button.
3. Scroll to ENABLE NAT, and press Enter.
4. Press
to select YES, and press Enter.
Setting Ring Tones
The IP 710 phone has 14 ring tones available. To set the ring tone: