Agri-Fab 45-02143 - Manual (Page 6)

6
FIGURE 8
FIGURE 9
18. Hook the free end of the flow control rod through the
hole in the slide gate bracket located near the bottom
of the hopper. See figure 10.
FIGURE 10
FIGURE 11
15. Assemble the flow control arm to the flow control
mounting bracket using a 1/4" x 1" hex bolt, two nylon
washers and a 1/4" nylock nut as shown in figure 8.
Tighten carefully. The flow control arm should be
snug, but should pivot with no more than a slight
resistance.
16. Assemble the vinyl grip. See figure 8.
17. Place a 5/16" flat washer onto the end of the flow control
rod. Insert the end of the flow control rod through the
slot in the flow control mounting bracket and through
the hole in the flow control link. Secure with a 3/32" x
3/4" cotter pin. See figure 9.
19. Assemble both the flow control mounting bracket and
the short handle tube to the long handle tube. Use two
1/4" x 1-3/4" hex bolts, four 5/16" flat washers and two
1/4" nylock nuts as shown in figure 11.
Do not tighten
at this time.
20. Place a handle grip on each handle. See figure 11.
1/4" x 1-3/4"
HEX BOLT
1/4" NYLOCK
NUT
HANDLE
TUBE
(SHORT)
HANDLE
TUBE
(LONG)
HANDLE GRIP FLOW CONTROL
MOUNTING BRACKET
5/16"
FLAT
WASHERS
HOPPER
SLIDE
GATE
BRACKET
FLOW
CONTROL
ROD
1/4" x 1"
HEX BOLT
1/4" NYLOCK
NUT
FLOW CONTROL
MOUNTING
BRACKET
FLOW
CONTROL
ARM
(2) NYLON
WASHERS
VINYL GRIP
FLOW
CONTROL
ROD
FLOW
CONTROL
LINK
3/32"
COTTER
PIN
5/16" FLAT
WASHER
SLOT