beautypg.com

Agri-Fab 45-02143 User Manual

Page 5

background image

5

FIGURE 7

12. Assemble the leg stand tube to the handle tube (long)

using two 1/4" x 1-1/2" hex bolts. Secure tightly with
two 1/4" nylock nuts. See figure 6.

13. Place a vinyl cap over the end of the leg stand tube.

See figure 6.

FIGURE 5

FIGURE 6

14. Assemble the flow control link (end with small hole)

to the flow control arm using a 1/4" x 1" hex bolt, a
nylon washer and a 1/4" nylock nut as shown in figure
7.

Tighten carefully. The flow control link should not

be loose but should pivot with no more than slight
resistance.

HANDLE TUBE (LONG)

1/4" x 1-1/2"
HEX BOLTS

1/4"
NYLOCK
NUT

VINYL CAP

LEG STAND TUBE

FLOW CONTROL

LINK

FLOW

CONTROL

ARM

1/4" NYLOCK NUT

1/4" x 1"

HEX BOLT

SMALLEST

HOLE

NYLON

WASHER

IMPORTANT: Do Not asssemble handle tube to same
side of crossover tube as shaft support plate.

8.

Place the long handle tube onto the crossover tube
on the

side opposite from the shaft support plate.

Fasten with the bolt, flat washer and nut removed in the
previous step. See figures 4 and 5.

Do not tighten at

this time.

9.

Assemble two handle braces to the inside of the hopper

frame, one on each side, using two 1/4" x 1-1/2" hex
bolts and two 1/4" nylock nuts. See figure 5.

Do not

tighten at this time.

10.

Assemble the other end of the two handle braces to the

long handle tube using a 1/4" x 1-1/2" hex bolt and 1/4"
nylock nut.

Do not tighten at this time. See figure 5.


11.

Tighten all hex lock nuts and bolts in same sequence
as assembled in steps 9 through 11. See figure 5.

MIDDLE
BOLT &
WASHER

MIDDLE
NUT

HANDLE TUBE (LONG)

HEX BOLT
1/4" x 1-1/2"

HEX BOLT
1/4" x 1-1/2"

HITCH
BRACE

1/4"

NYLOCK

NUT

CROSSOVER
TUBE

SHAFT
SUPPORT
PLATE