ATEN CS-228 - Manual (Page 19)

Setting Function
SET PASSWORD This function is used to set passwords for the Administrator and User:
1. One Administrator and two User passwords can be set.
2. Move the highlight bar to User or Administrator, then press [Enter].
A screen that allows you to key in the password appears. The
password may be up to 8 characters long, and can consist of any
combination of letters and numbers (A - Z, a - z, 0 - 9).
3. For a new password, key in the new password. To modify or delete
a previous password, use the backspace key to erase individual
letters or numbers, then key in the new password.
4. Press [Enter]. You are asked to key the password in again, in
order to confirm that it is correct.
5. Key in the new password again, then press [Enter].
If the two entries match, the new password is accepted. If the
entries do not match, you must start again from the beginning.
6. If the Administrator wants to change a User’s password, he must
enter his Administrator’s password first.
SET ACCESSIBLE
PORTS This function allows Administrators to select which Ports can be
accessed from a particular Console. Move the highlight bar to the
target computer, then press [Enter] or the [Spacebar] to toggle
access On and Off. If access is On, a plus mark ( + ) appears to
indicate so. If access is Off, the area is blank. Make your choice,
then press [Esc] to confirm.
SET MULTIUSER MODE This function determines whether or not the same ID can be used to
log into the CS-228 from the second Console at the same time that
it is being used at the first one.
1. If Disabled, the same ID cannot be used; if Enabled (the default),
the same ID can be used to log in from the second Console.
2. If Enabled, the F4, F6, and F7 settings set for any one Console,
will be the same for all other Consoles that log in with the same ID.
3. Changes made to the F4, F6, and F7 settings by any logged in
Console will automatically affect all Consoles with the same ID.
SET ACCESS TIMEOUT This function is used to set the timeout value to control the release of
access rights to a computer. If the original Console doesn’t access
the computer before the timeout value is reached, the computer
becomes available to the other Console. To set the timeout value,
key in a number from 2 - 255 seconds, then press [Enter] (if the
number is 0 (zero), this function is disabled. Default is 10 seconds.
CLEAR THE NAME LIST This function is used to undo all Administrator changes and return
the setup to the original factory default settings.
Note: While this function is in progress, make sure that no other
operations are performed on the other Console.
RESTORE DEFAULT
VALUES This function is used to undo all Administrator changes and return
the setup to the original factory default settings - except for the
Names that were assigned to Ports, which are saved.
2001-02-01
CS-228 User Manual 15