AOC CT700G - Manual (Page 5)

6
ADJUSTING THE PICTURE
1. CONTRAST Adjust the picture contrast.
2. BRIGHTNESS Adjust the picture brightness.
3. H- CENTER
Adjust the horizontal position
of the picture.
4. H- SIZE
Adjust the picture’s horizontal
size.
HOW TO ADJUST A SETTING
1. Press the Shuttle Knob Key to make the OSD window
appear. See figure 4.
2. Rotate the Shuttle Knob to select the desired function.
See figure 4.
3. Press the Shuttle Knob again to select the function that you
want to adjust.
4. Rotate the Shuttle Knob to change the settings of the current
function.
5. When the OSD window is active, it shows the input signal
timing. The "H" stands for the horizontal frequency and "V"
for the vertical frequency.
6. To exit and save, select the exit function, or leave the monitor
alone for 10 seconds. If you want to adjust any other function,
repeat steps 2-4.
1024 X 768
Figure 4 The OSD Message
CONNECTING CABLES
1. Power Cord 4. PC Audio Output
2. Signal Cable 5. DC Output
3. VGA Card Adapter
EXTERNAL CONTROLS
1. Shuttle Knob
2. Power Indicator
3. Power button
FRONT PANEL CONTROL PANEL CONTROL

Power button :
When pressed, the monitor enters the off mode, and
the LED flashes. Press again and hold to restore
normal status.

Shuttle Knob :
The Shuttle Knob is used to control the monitor
functions. Rotate to switch functions or adjust settings.
Press to select or execute a function .

Power Indicator :
Green — Power On mode.
Blinking Green — Off mode.