Panasonic SAHE40 - Manual (Page 20)

20
RQTV0109
Other settings
Other settings
INPUT SELECTOR TUNE MENU
RETURN
SETUP
MUSIC PORT
VOLUME
ENTER
TUNE MENU
RETURN
SETUP ENTER
Setting descriptions
INPUT MODE (Input mode)
This unit automatically detects whether input is digital or
analogue, but you can fix the input mode.
AUTO: The unit automatically detects whether input is digital
or analogue.
ANALOG: Select to make the unit accept analogue input.
DIG: Select to make the unit accept digital input.
PCMFIX
1 : Select to input to PCM.
A
DRCOMP (Dynamic range compression)
Change this setting to listen to software recorded with Dolby
Digital at low volume (such as late at night) and maintain
audio clarity. It reduces the peak level in loud scenes without
affecting the sound field.
OFF:
The software is played with the original dynamic range
(factory setting).
STANDARD:
The level recommended by the producer of the software for
household viewing.
MAX:
The maximum allowable compression (recommended for
night viewing).
B
ATTENUATOR (A/D Attenuator)
Turn the A/D attenuator on if "OVERFLOW" lights frequently
when using 2-channel analogue input.
C
DTS-PCM
If you are playing a DTS CD that contains both DTS and
PCM, but it isn't playing properly, then select "YES".
If this causes noise to occur, return the setting to "NO". (This
setting is effective for each digital source.)
D
Changing the settings
1. Press and hold [ ―SETUP] to enter the setup menu.
2. Press [TUNE - or +] to select the item you want to
change ➡ [ENTER].
3. Change the settings.
INPUT MODE
1. Press [TUNE - or +] to select "TV" or "DVR" ➡ [ENTER].
2. Press [TUNE - or +] to change the setting.
The display changes as follows:
AUTO ↔ ANALOG ↔ DIG ↔ PCMFIX
DRCOMP
Press [TUNE - or +] to select "OFF", "STANDARD" or
"MAX".
ATTENUATOR
Press [TUNE - or +] to select "OFF" or "ON".
DTS-PCM
Press [TUNE - or +] to select "NO" or "YES".
4. Press [RETURN] repeatedly until "EXIT" appears
➡ [ENTER].
A
B
C
D
1 In rare cases, the unit may have trouble recognizing PCM signals and this may cause the beginnings of tracks to be cut off.
Select “PCMFIX” if this occurs.
With DTS, the signals may not be recognized at all. Engage the DTS FIX mode if this occurs.
To engage the DTS FIX mode:
Press and hold [-MENU] and [ENTER] at the same time.
"DTS" lights.
To cancel the DTS FIX mode:
Press and hold [-MENU] and [ENTER] at the same time.
The mode cancels when input mode is set to AUTO or when the unit is turned off.
When a FIX mode is on, the unit cannot process other signals. This may cause noise to be output. If this occurs, select an input
mode other than PCMFIX, or cancel the DTS FIX mode.
•
Note
20
SA-HE40(RQTV0109-1E).indb 20 2/22/2006 4:33:26 PM