Panasonic ERGS60 - Manual (Page 13)

13
English
Trimming around the ears and neckline in wet/dry
1. Attach the desired comb
attachment to the main body.
2. Holding the clipper with the
power switch at the bottom,
trim around the ears and
neckline (
) by lifting the
tip of the comb attachment
little by little from the hairline.
• When trimming the entire
area to 9 mm, use 6 mm as a
rough standard trimming
height for the neckline.
Trimming the downy hair around the neckline
in wet/dry
1. Remove the comb attachment.
2. Hold the clipper with the power
switch upward, touching the
blade perpendicular to the area
of downy hair, and move the
clipper downward along the skin.
90°
• To maintain sharpness, remove the hair trimmings between trimmings.
• It is recommended to ask someone else to trim around your own
ears and neckline.
Cleaning the clipper
• It is recommended to clean at every use.
• Always wash with water after wet trimming.
1. Remove the clipper from the AC adaptor.
▼ ▼
To remove light dirt To remove heavy dirt
2. Remove the comb
attachment and turn the
clipper on.
3. Run water down the water
inlet at the back of the main
body, rinse thoroughly for
approximately 20 seconds,
and then turn the clipper off.
• Rinse with water and
shake up and down
several times to remove
the water.
2. Remove the comb
attachment and blade.
3. Clean the clipper, the blade
and the comb attachments
with running water.
• Rinse with water and
shake up and down
several times to remove
the water.
▼ ▼