Aquacal 100 EN - Manual (Page 33)

33
INSTALLATION INSTRUCTIONS (continued):
Electrical Requirements -------------------------------------------44
General Requirements ------------------------------------------44
Code-Specific Requirements -----------------------------------44
Connecting External Controllers --------------------------------44
Sizing the Electrical Service ------------------------------------45
Ground Fault Protection (not recommended) ------------------45
CONTROLS CONFIGURATION & ADJUSTMENTS ----------------------46
Level-2 (dealer-service) Programming ----------------------------46
1. Entering Service Menu ---------------------------------------46
2. Time Delay ---------------------------------------------------47
3. Configuring for External Controllers -------------------------47
4. Water Sensor Calibration ------------------------------------47
5. Defrost Sensor Calibration -----------------------------------48
6. Spa Dead Band Differential (and adjustment) --------------49
7. Pool Dead Band Differential (and adjustment) -------------49
8. Changing Service Lock Code & “Back Door” Entry ----------50
Level-2 Set Up & Calibration Codes -------------------------------51
Factory Default Settings -------------------------------------------51
Troubleshooting Using Displayed Codes --------------------------52
Mode Jumper and Positioning -------------------------------------53
Defrost Systems (described and explained) ----------------------55
Water Flow Pressure Switch Adjustment--------------------------56
CONTACTING THE FACTORY ------------------------------------------58
DEALER-SPECIFIC TABLE of CONTENTS
(CONTINUED)