Sony VPL-HS1 - Manual (Page 15)

15
GB Projecting the Picture on the Screen
P
rojecting
*
Set the INPUT-A setting in the SET SETTING menu
according to the input signal. ( 1 page 20)
5
Move the zoom lever to adjust
the size of the picture.
6
Move the focus lever to adjust
the focus.
Adjust to obtain sharp focus.
7
Press VOLUME + or – to adjust
the volume.
To turn off the power
1 Press the [ / 1 (on/standby) switch.
A message “Power OFF?” appears on the screen.
2 Press the [ / 1 switch again.
The ON/STANDBY indicator flashes in green and
the fan continues to run to reduce the internal heat.
Also, the ON/STANDBY indicator flashes quickly
during which you will not be able to light up the
ON/STANDBY indicator with the [/1 switch.
3 Unplug the AC power cord from the wall
outlet after the fan stops running and the
ON/STANDBY indicator lights in red.
You can turn off the projector by holding the [/1 (on/
standby) switch for about one second, instead of
performing the above steps.
To view the picture
from Press
INPUT to
display Sound is
heard from the
equipment
connected to
Video equipment
connected to VIDEO
INPUT on the projector VIDEO 1 AUDIO INPUT
Video equipment
connected to S VIDEO
INPUT on the projector S-VIDEO 1 AUDIO INPUT
RGB/component
equipment connected to
PJ MULTI INPUT via
the optional signal
interface cable or the
interface unit INPUT A
*
PJ MULTI
INPUT
Video equipment
connected to PJ MULTI
INPUT via the optional
signal interface cable or
the interface unit VIDEO 2 PJ MULTI
INPUT
Video equipment
equipped with S VIDEO
connected to PJ MULTI
INPUT via the optional
signal interface cable or
the interface unit S-VIDEO 2 PJ MULTI
INPUT
“Memory Stick”
inserted into the
“Memory Stick” slot MS AUDIO INPUT
Zoom lever
Focus lever
VOLUME
+
–